Request a Quote
Home · Articles · Aggregate & Mining
Aggregate & Mining

Aggregate: 70% of concrete and the silent determinant of quality.

We talk about cement and debate admixtures, yet roughly seventy percent of concrete by volume is aggregate. Good concrete cannot be made with poor aggregate.

10 July 20268 min read Ozan Global Holding
How Does Aggregate Quality Affect Concrete? Milas Limestone, Crushed Stone and Sand

Good concrete starts with good aggregate. Cement is the binder, but it is the aggregate that builds the load-bearing skeleton. With poorly graded, unwashed or excessively fine aggregate, whichever cement you use, the result is disappointing.

Why is aggregate so decisive?

  • Volume: About 70% of concrete is aggregate, so the scale of any error grows in proportion.
  • Water demand: Poor grading needs more water for workability, and every extra litre lowers strength.
  • Bond: Clay and dust on the aggregate surface stop the cement paste from adhering to the particle.
  • Dimensional stability: Suitable aggregate reduces shrinkage and the tendency to crack.

Milas limestone: the backbone of the region’s aggregate

The limestone reserves in and around Milas are the raw material of Muğla’s road and building production. Limestone aggregate is hard, abrasion-resistant and bonds well with cement paste. Material from the quarry is processed in the crushing-screening plant, washed and separated into fractions.

FractionTypical sizeUse
Sand (0–4 mm)Fine aggregateConcrete, plaster, screed
No.1 crushed stone (4–11 mm)Fine crushed stoneConcrete, asphalt, precast
No.2 crushed stone (11–22 mm)Medium crushed stoneStructural concrete (Dmax 22)
Fill / sub-baseAll-inRoad sub-structure, levelling

Grading: the right distribution of particles

A good aggregate blend balances different sizes so as to minimise voids. Smaller particles fill the gaps between the coarse ones, and sand fills the gaps between those. The fewer the voids, the less cement paste — and therefore less water — is needed for the same workability.

Rule of thumb

Aggregate without a sieve analysis is concrete without control. Ask your supplier for regular sieve analysis and washing-loss reports.

Fines, clay and washing

Clay and silt in the aggregate prevent the cement paste from adhering to the particle and increase water demand. Strength loss and shrinkage cracking are common in concrete made with unwashed aggregate. That is why aggregate is washed at the plant and the fines content kept within the limits set by the standards.

How to choose the right aggregate

  1. Choose a supplier with a known source that is fed continuously from the same quarry; a change of quarry upsets the mix design.
  2. Verify that fractions are stockpiled separately; a mixed stockpile on site leaves the grading to chance.
  3. Ask for washing and sieve analysis reports.
  4. Avoid sea sand and unwashed river material; they carry chloride and clay risks.
  5. Make sure your batching plant and your aggregate source work in step — ideally, both are under the same roof.

See İTS Maden for our aggregate production in Milas and Bodrum Beton for the ready-mix concrete we produce with it.

Frequently Asked Questions

What is the difference between crushed stone and gravel?
Crushed stone is produced by crushing rock; it is angular and rough, with a strong bond to cement. Gravel is naturally rounded; it gives good workability but a weaker bond.
How does clay in aggregate affect concrete?
Clay coats the particle surface, preventing the cement paste from adhering and increasing water demand. The result: lower strength, more shrinkage and cracking.
Which maximum aggregate size should be chosen for concrete?
Dmax 22 mm is generally used in structural concrete. Smaller sizes (Dmax 16 mm) may be preferred in densely reinforced elements and larger sizes in mass concrete.